Pool Closing Checklist
Enter your pool type, climate and last test results to get a winterizing checklist with your chemical amounts and the gallons to remove when lowering the water, ready to print.
Last reviewed · How we calculate
Your result
—
- Shock level
- —
- Water to remove
- —
Add one product at a time with the pump running and retest before the next. Never mix chemicals together.
How to close a pool for winter
Closing a pool well is mostly about two things: water that is balanced and sanitized enough to sit for months without turning green or attacking the surface, and plumbing that holds no water for ice to crack. This pool closing checklist turns your test results into amounts and adjusts the steps for in-ground or above-ground pools and for freezing or mild winters. Start about a week before you plan to put the cover on.
Balance the water first
Cold water is more aggressive toward plaster and grout than warm water at the same pH, and covered water is not tested for months, so close with the water in the middle of the normal ranges. Common guidelines: pH 7.4–7.6, alkalinity around 80 ppm (70 for salt pools), calcium around 300 ppm for plaster and 200 ppm for vinyl or fiberglass. The checklist lists each adjustment with its amount, or marks it as fine. In the default example — a 15,000 gallon plaster pool with pH 7.8, alkalinity 90 and calcium 300 — only pH needs work: about 15.2 fl oz of 31.45% muriatic acid brings it to 7.5. Use the pH calculator if you want to see the effect of alkalinity and stabilizer on that dose.
Shock, then let chlorine settle
A few days before closing, raise free chlorine to a shock level — the checklist uses about 40% of your stabilizer reading, a widely used guideline. At 50 ppm CYA that is 20 ppm; starting from 2 ppm in 15,000 gallons, it takes about 2.16 gallons of 12.5% liquid chlorine. Run the pump at least 24 hours so it reaches every part of the pool. Then wait until chlorine has fallen back to around your normal target before adding winter algaecide and covering: very high chlorine under a cover can fade the cover and liner, and it destroys some algaecides. The pool shock calculator shows doses for other products.
Do not leave a chlorine floater or tablets in a closed pool. A trichlor floater can get trapped against a vinyl liner or plaster wall and bleach or etch it, and trichlor keeps adding acid and stabilizer to water that is not circulating. If you must use one in a mesh-covered pool, tether it in the middle and check it — but most pool techs simply remove it.
Lowering the water
In freezing climates, water left in the skimmer can freeze, expand and crack it. The usual approach for an in-ground pool is to lower the water to just below the skimmer opening — commonly 4 to 6 inches below it — and to follow the cover maker's instructions, since some mesh covers call for a lower level and some solid covers rely on the water to support them. The calculator turns inches into gallons: each inch over each square foot is about 0.623 gallons, so a 512 sq ft pool loses about 319 gallons per inch and about 1,915 gallons for 6 inches.
Above-ground pools are different. Lower the water only to just below the skimmer and return fittings, or not at all if you fit a skimmer plug or cover plate. Never drain a vinyl above-ground pool far down: the liner can shrink and the walls depend on the water to hold their shape. Check gallons for your size with the above-ground pool gallons calculator.
| Surface | Per inch | 6 inches | 18 inches |
|---|---|---|---|
| 452 sq ft (24 ft round) | 282 gal | 1,691 gal | 5,072 gal |
| 512 sq ft (16 × 32) | 319 gal | 1,915 gal | 5,745 gal |
| 648 sq ft (18 × 36) | 404 gal | 2,424 gal | 7,271 gal |
| 800 sq ft (20 × 40) | 499 gal | 2,992 gal | 8,977 gal |
Plumbing and equipment
For in-ground pools in freezing areas, blow air through each line from the equipment pad until no water comes out of the returns and skimmers, then plug them. Some installers add pool antifreeze, which is propylene glycol made for pools — never automotive antifreeze, which is toxic. Remove the drain plugs from the pump, filter, heater and any chlorinator so no water is trapped, and keep the plugs in the pump basket. Store a salt cell indoors and dry. For above-ground pools, disconnect the hoses, plug the wall fittings, and bring the pump and cartridge indoors if you can. Put an air pillow under an above-ground cover so ice pushes against the pillow instead of the walls.
Mild winters
Where hard freezes are rare, many owners keep the pool running through winter instead of closing it: fewer pump hours, chlorine kept at target, and the pump's freeze-protection setting turned on if it has one. Salt cells produce less chlorine in cold water and some shut off below a set temperature, so test weekly and add liquid chlorine if needed. Choose "Mild, rare frost" for that version of the checklist.
Through the winter
Pump rain and snowmelt off a solid cover, clear leaves, and check that the water level has not dropped (a sinking level under a cover can mean a leak or tear). In spring, the pool opening checklist reverses the process with your new test results.
Safety: wear eye protection and gloves when handling acid and chlorine. Always add chemicals to water, never water to chemicals, and never mix acid with chlorine or two chlorine products together. Follow every label. A winter cover is not a safety barrier unless it is a certified safety cover — keep children and pets off it.
Questions people ask
How do you close a pool for winter?
About a week ahead, clean the pool and filter and balance the water (pH 7.4–7.6). Shock a few days before closing, let chlorine fall back to normal, then remove accessories, lower the water where needed, blow out and plug the lines, drain the equipment and fit the cover.
How far do I lower the water to close an in-ground pool?
A common guideline is to lower it to just below the skimmer opening, often 4 to 6 inches below it, so ice cannot crack the skimmer; mesh-cover makers sometimes ask for more. In a 16 × 32 ft pool each inch is about 319 gallons, so 6 inches is about 1,915 gallons.
Should I drain my above-ground pool for winter?
No. Lower it only to just below the skimmer and return, or not at all if you use a skimmer plug or cover plate. A vinyl liner needs the water's weight to hold its shape, and an empty liner can shrink or tear.
How much shock do I need to close my pool?
A common target is about 40% of your stabilizer level. At 50 ppm CYA that is 20 ppm; in a 15,000 gallon pool already at 2 ppm, it takes about 2.16 gallons of 12.5% liquid chlorine. Close once it has fallen back to your normal level.
Can I leave a chlorine floater in my pool over winter?
It is better not to. A trichlor floater can become trapped against the liner or wall and bleach it, and trichlor keeps adding acid and stabilizer to water that is not circulating. Remove floaters and tablets before you put the cover on.